Ask questions and find answers on ST MEMS sensors, such as the LSM6DSV and the LSM6DSL. Learn how to use the SensorTile.Box, and STEVAL kits.
Hi, I am working on high precision position control with BLDC motors on my master thesis. I am trying to control the position with an encoder on the TI-C200 processors and It's ok for now. The control accuracy is 0.1 degree on the encoder but for my ...
The MotionFX Library is initialized as follows: MotionFX_getKnobs(&iKnobs); /* Modify knobs settings */ // Configure knobs with non-default values iKnobs.output_type = MFX_ENGINE_OUTPUT_ENU; iKnobs.modx = 1; // No decimation iKnobs.ATime = 10; // ka...
Hi! Since I am not a native speaker, I apologize in advance for my English.When switching on the pulsed mode strange things start to happen. Until yesterday I used int1 pad, everything worked fine, but at a certain moment it became necessary to count...
hello,I am trying to get the LSMDSO32 to work with https://github.com/STMicroelectronics/STMems_Linux_IIO_drivers branch 4.19 built on 5.4 kernel.I am able to build the kernel image on 5.4But when i try to insmod the modules i get the following error...
I have generated the binary file through StmCube32 IDE for audio recognition.Am not able to do the program in Steval-MKSBOX1V1 kit. How to do the Programming using USB?
Hi,We are running a vibration analysis system based on the LSM6DS3. This is FIFO based, and everything works as expected. Application is accel only.However when enabling the high pass filter from the digital composite filter, all readings out of the ...
Hi!I purchased X-NUCLEO-53L1A2 and tried to check the function.However it was impossible to connect VL53L1 breakout board through left and right connectors.Because there were not left and right connectors. I attached the picture. But about X-NUCLEO...
Hi.According to the DS of the LPS33W - the Reflow profile should be according to JEDEC J-STD-020 , with no actual determination of the profile.we had several boards assembled , and with very little force applied, the sensor disintegrated - the metal ...
Single-tap exampleHereafter an example code which implements the SW routine for single-tap detection.1. Write 60h in CTRL1// Turn on the accelerometer// ODR = 400 Hz, FS = ±2 g2. Write 38h in CTRL3 // Enable tap detection on X, Y, Z-axis3. Write 09h ...
I've got something really screwy going on with the LSM6DSOX chip. I've got it hooked up in simple form using 4 wire SPI mode 0 and 3. I can talk to the chip just fine. Read and write no problem.The first problem is that I want to do a SW reset. Setti...
