Ask questions and find answers on ST25 NFC/RFID tags and readers, including connectivity implementations and antenna design.
Hello,I am designing an NFC reader based on the ST25R95 transceiver and I would like to use the ST online NFC Tuning Circuit / Antenna Matching Tool to calculate the antenna matching network.However, I cannot find the ST25R95 among the selectable ICs...
Hi,Follow-up to my earlier thread:https://community.st.com/t5/st25-nfc-rfid-tags-and-readers/st25r3911b-disco-for-rfid-mid-range-in-a-box-with-constraints/m-p/894801#M13962where a similar hand-wound loop approach was discussed, I tried to reproduce i...
Hello all,I am trying to read NFC Type V (ISO15693) tags using an ST25R200 and an ESP32-S3. For this purpose, I am using the ST25R200 evaluation kit and have connected the ESP32-S3 by soldering enamelled copper wires to the exposed pads on the develo...
Hello, i need help for an issue with HLTA command.I'm working with ST25R100 and I'm writing code direclty in uP without RFAL library. I finished writing anticollision routine and it works fine, but when I try to put PICC in HALT mode it continues to ...
Hi STM teams , i have developed a custom NFC board using the STM32L476RCT6 and the ST25R3916B NFC reader, based on the reference design of STEVAL-D25R16B (https://www.st.com/resource/en/schematic_pack/steval-25r3916b-schematic.pdf). I am using an ext...
Hello,I start testing with the STEVAL-M25R16B Board and use this Time the self compiled Demo from ST to test it. All works find.Then i made an own PCB with Reader IC and Antenna on it and connect it to your MCU /Display Board.The Board is connected ...
antenna tuning section pinout is correct or not capacitor section@Dilip im facing issue for developing A SMART RFID reader using ST25R3912-AQWT this chip as per the application circuit it was mentioned RFO1 AND RFO2 are trasmitter pins but what about...
Hi everyone! I'm working with the NFC07A1 board associated with the Nucleo L053R8, with the intention of being able to perform ADC readings. I configured everything(ADC, pin, NFC07A1, etc.) on CubeMx, and then, opened the generated file on CubeIde. A...
Hello There,I am currently trying to use the ST25R200 with the X-CUBE-NFC10 Software package.First thing am not sure about: In the "Software Packs Component Selector" I have to configure the "Board Extension NFC/NFC10A1" even when i don't plan to use...
I am using the STEVAL-25R300KA board with ST25PC-NFC version 3.0.2 on a PC running Windows 11.The software opens for a few seconds and then closes automatically by itself. I have already tried the following steps:Reinstalled the softwareRestarted my ...
