Ask questions, find answers, and share insights on STM32 products and their technical features.
Development tools:windows; VScode; CubeIDE for VScode Extension; STM32CubeMX; STM32CubeProgrammerAfter three days of torment, I finally managed to download it, in LRUN mode.But debugging still doesn't work in VScode. I don't know if LRUN mode require...
Good morning, I'm writing because we are spending a lot of time in the last weeks due experiencing a problem accessing the 64MByte external RAM (IS66WVH64M8DBLL-166B1LI) via Hyperbus on our target board. If we replace the ISSI memory with a Cypress/I...
Heyho,strange problem here with some H723, internal flash divided into bootloader and application section.Everything worked fine for some time, now I have a problem with some variables in DTCM RAM, when the application updates the bootloader flash.Be...
Issue facing in programming stm32f469bit series microcontroller custom pcb. One time programming is fine , later it cannot be programmed. why is this isuue?
I have a requirement from customer to read the mains input voltage (down converted to 3.3V) which is 50Hz using ADC and identify the phase delay between the input and after the ADC reading(Ideally it shall be 0 requirement). How to demonstrate? I am ...
I know that, for lowest power, it's recommended to switch GPIOs to analogue in. But I require outputs to keep a defined level during low-power (STOP). As far as an STM32F030 is concerned, is there any power consumption advantage to choose between usi...
Dear ST Team,We received parts with COO showing as ,misspelling "United Stat", missing "es" at the end. Could you please help advise if this is due to label format restriction to miss "es" at the end or other reasons? Thank you.STM32F103RCT6STM32F103...
Hello,I'm having trouble getting a lock with the DCMI. Lots of information below as required.Has anyone seen ACTCLF permanently stuck at 0 on STM32N6 despite confirmed HS clock at the input? Are there any additional SNPS D-PHY initialization steps be...
Hi ST Community,I'm working on a custom board with STM32N6, and I plan to connect 4 MEMs microphones ( MPN: MP23DB01HPTR) to MDF1 interface. From my understanding, I need to use 4 instances ( Instance 0,1,2,3).Here is my Mics schematic : How should I...
From my understanding im doing everything right im using a stm32f446re. I've tried using cube ide where all the peripherals are loaded for me and it still doesn't seem to transmit i cannot see anything in the Putty or even the stm32 console. someone ...
