Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
I am analyzing the UART data frame of an outsourced device that uses the STM8S105 MCU. The data frame specification is:* 1 start bit,* 8 data bits, * 1 parity bit,* 2 stop bits.Therefore I expect a data frame as in the below Figure 115 from the STM8 ...
Code shown in details. I am guessing something is wrong with clocks - this doesn't make sense though since tx is working just fine. I see signals just fine on the scope. Both tx and rx are high during no transmit. Clocks and initialization code shown...
i had received this function from the ST Micro self test evaluation package for MCU STM8S207RB
FERD40U45CTTwin diode with very low voltage drop and has a small PCB foorprint.
