Ask questions, find answers, and share insights on STM32 products and their technical features.
Posted on December 10, 2017 at 16:56Hey,I am trying to test my MCU with the sequence bellow in order to check if i get time drift on the RTC clock.loop on :1. print RTC time + date2. enter stand by modeI tested the wake up from stand by mode with :...
Posted on December 11, 2017 at 14:58Hi everyone,I am using STM32F769I Eval Board and i am trying to run the STM32Cube_FW_F7_V1.7.0 CAN_Networking example.First i read the documentation and set the jumpers +-------------+-----------------+ | ...
Posted on December 04, 2017 at 07:05We are trying to communicate ST disco board with atmel board using example code of SPI.We have configured spi clock frequency 500000hzclock phase and clock polarity as zero, in atmel board.where to configure spi ...
Posted on December 11, 2017 at 12:40i want simple code in main.c file without any library !i am using 1) stm32cubeMX and 2) Atolluc true studio3) BMP180 sensor 4) Stm32f103c8if any one can have a solution then kindly share it ! Thanks in Advanced !!...
Posted on November 14, 2016 at 14:02 I'm trying to get the SDADC on a STM32F373 working for muti-channel acquisitions using the HAL (and not standard peripheral library). I've not found a good multi-channel tutorial/example that uses the HAL, so I...
Posted on December 11, 2017 at 10:51Hello!i am working with the STM32F437IIT6, i have an issue regarding the I2C.While working with some device on the I2C bus i can expirience a situation in which the busy bit in the SR2 register is always high.whe...
Posted on December 11, 2017 at 11:00hello,i need to open a serial port for printf perpouses (it cant be in the debug viewer), i believe i have installed all required drivers, but my board is not recognized in Device Manager->Ports (it does recognize...
Posted on December 07, 2017 at 16:00Which STM32 has the actual lowest running current consumption (active from flash)?#stm32-lowest-current
Posted on December 02, 2017 at 21:44Hi!I am using CubeMX and System Workbench, and an STM32F030f4p.In CubeMX I enable only one GPIO port so I can turn on-off the LED on the board, and RTC Alarm A.In the code I turn on the power clock with__HAL_RCC_P...
Posted on December 07, 2017 at 10:52I am working on STM32F100 with SPI Flash(Winbond - W25Q80BV) Interfacing. In my coding write page function, read page function, erase chip and erase sector function working properly. Status register also read prop...
We’re moving the ST Community to a new platform to give you a better and more reliable community experience.
