Ask questions, find answers, and share insights on STM32 products and their technical features.
Hi, I was facing one issue..while running firmware in my device (stm32f4)in the middle suddenly controller got restarted, when I checked that RCC reset status register and I got to know that power on reset ,but I didn't restart my device only , May I...
Hi everyone, I am a bit confused about this.In STM32CubeMX tool, I configured SDRAM 100MHz, the tool GUI shows result 100MHz as well, then I generate code then test.I check SD clock pin, it is 10ns on each single clock, no matter the clock is high or...
para aplicar i2c alternate function open-drain GPIO_InitStruct.Pull = GPIO_PULLDOWN o should be GPIO_PULLUP (what diferencetween both) and uart alternate function push-pull should be pull-up or pull-down what diferencetween both?
Hello,I am relatively new here and would like to try to design a STM32H747AI board with LiPo battery power supply for wearable devices with features like OLED microdisplay, WiFi+Bluetooth and GNSS module. Since I would like to run a GUI on it with sm...
Does the STM32 NUCLEO BOARD STM32F446RE have internal pull-up resistors for I2C communication?
1. I am implementing a custom extended kalman filter function. The program on running hits HardFault handler on the 4th iteration (prediction function).2. Cortex-M4->CFSR = 0x8200 (BFARVALID=1)3. BFAR holds : 0xa5a5a5a5I am not able to understand whe...
Posted on November 11, 2015 at 17:50 Hi every one, especially Mr.Clive, today i have problem with CAN FILTERS i want to allow all IDS from 100 to 1FF in other words block all messages after 0x0200 here is my code, Please help me, Thanks in...
I bought STM32L073RZT6 and LAWAN1 expansion board, will STM32F103RB and LAWAN1 be compatible?
When used on STM32L4xx platforms (and possibly others), with flash configured for single-bank mode, the EEPROM emulation library (https://www.st.com/en/embedded-software/x-cube-eeprom.html) miscalculates flash sectors which causes silent erase failur...
Hi, I am using the STM32L45 series in my HW and I wonder if it can support I3C protocol?If not, is there another compatible MCU you would recommend?Thanks, yy
We’re moving the ST Community to a new platform to give you a better and more reliable community experience.
