MEMS (sensors)

Resolved! Is the decision tree running on the ISM330DHCX or on the microcontroller? Is the ISM330DHCX able to work independently from the FW loaded in the host microcontroller?

Resolved! The output data from the sensor in STWIN can be displayed directly on the PC in real time?

Resolved! Is there any difference between a "vibration sensor" and an accelerometer?

Resolved! In ISM330DHCX the MLC can run up to 104Hz, that means that we cannot detect any abnormal frequency above 52 Hz? Why is the MLC limited to 104Hz if the maximum sensor ODR (Gyro or XL) is 6.67kHz?

Resolved! To train the MLC Decision tree, can the training dataset be generated based on simulation?

Resolved! Hi, I got the STWIN Starter Kit. Shortly After connecting the STLINK-V3Mini via USB-Cable it is getting quite hot. Is this Problime familiar? Thanks in advance

Also I got the Error seen on the picture. I am a newbie to the topic and just want to get the kit startet. Any Suggestions

Resolved! Hello ST Experts, I have get X-NUCLEO-AMICAM1 and NUCLEO-L4R5ZI separately. But alas X-NUCLEO-AMICAM1' pins may be fit for nucleo-64. How can do I mount it for NUCLEO-144's (as NUCLEO-L4R5ZI)?

Resolved! How to verify accelerometer data is correct or not?

I have read the accelerometer data using(H3LIS100DL) sensor then I got some negative value x=-3, y=-2, z=-1. I used these register OUT_X(29h), OUT_Y(2Bh), OUT_Z(2Dh). My question is how to verify these accelerometer X, Y, Z data is correct or not?

Resolved! hello sir, i want to ask something about how to access IC MCP3909. is there any example to access ic mcp3909. I'm having trouble reading the datasheet to determine which register is used to access the sensor and also to calculate it thank you

I ask this method because I am familiar with Arduino, and I am a beginner in using Arm as embedded systems and also for my research