Ask questions and find answers on connectivity ICs, focusing on protocols and I2C challenges on STM32 Nucleo boards and BlueNRG products.
i use stm32f030 with bluenrg-1 on a card i made i want to test and communicate with it using the BlueNRG GUI --------------------------------------------------------------------------------------------------------------------------But I have problems...
Hello every onewe are using BlueNRG-1 for Our BLEFor the Information,We have connected 32MHz external crystal oscillator in HS Pins..We haven't connected any external crystal oscillator at LS Pins..And we haven't connected any inductor at SMPS pins o...
I am hoping this has a simple answer. If I develop a solution based on the BLUENRG-355MC and attribute that design is based STMicroelectronics SOC solution, are there additional fees I need to be aware of? I checked the following link:https://www...
Hello! I'm using module Bluenrg-355MT in my project. There is the antenna ACAG0801-2450-T on my board. This antenna transmits enough over a long distance (D>250m). But reception of this antenna is not more than 15m. Is it possible to achieve long ran...
I am trying to evaluate the BlueNRG-332AC using the IDB012V1A eval board.I have setup the BlueNRG GUI software. However, when trying to connect to the COM port, provided by the eval board, it says "No device detected!" followed by "No firmware detect...
I'm working on a new IOT device. I'm using your BLUENRG-232N device with STM32L496AGI6 microcontroller, and I'm using your STMicroelectronics.X-CUBE-BLE2 version 3.2.2 stack for the firmware and the application. but unfortunately the mcu goes into th...
Hi All,I want to ask "is it possible to run BLUENRG-355 on internal oscillator (64Mhz) "As per data sheet it supports internal HSI but device firmware says HSE only. /* High speed crystal configuration: BlueNRG-LP supports only HSE 32 MHz */ SystemTi...
Hi I am looking to used X-Nucleo-IDB05A2 board for BLE development.After reading about the information provided on the board page the only example project folder I got, i.e en.x-cube-ble2After going through all the project given in the folder I didn'...
There is a bug in S2LP_Library which is part of the STSW-S2LP-DK package. In the following function you need to shift xCcaLength to the upper nibble, but there is no shift in currently available version. The bug won't allow you to set CCA length.Plea...
We know that ST4SIM supports embedded Secure Element(eSE) applet to store and protect sensitive data and provides security services. We think the access to eSE via SPI by STM32 MCU is possible. How can we use this feature?
