Ask questions, find answers, and share insights on STM32 products and their technical features.
In the STM32F469, can the bus arbitration priority (amongst the different bus masters) be changed? From my reading of the Application Notes and the Reference Manuals this doesn't seem to be the case. But I'd like to get a confirmation just the same. ...
I have a bootloader project that can jump to a QSPI application under normal conditions. When I first install this application and then install my application that I created separately for QSPI, it works without any problem.(Bootloader + App).But wha...
The stm32h747 controls Flash memory using qspi.Flash is using mt25ql256.Write and Read actions have been confirmed.But the frequency doesn't come out like a data sheet in flash memory.The speed of the QSPI clock is around 1.25Mhz. QSPI ClockPrescal...
I'm trying to understand the USART1 boot loader operation on STM32C031F6P6. AN606 rev 63 pg 53 says USART1 Rx/Tx must be on PA11/PA12 (TSSOP20), but CubeMX 6.11.1 does not let me assign those functions to those pins. CubeMX wants to assign USART1_TX ...
Hi Team.I am reaching out to request assistance with the power budget calculation for the STM32U5A5QJI6Q microcontroller.Specifically, I would appreciate it if you could provide a detailed breakdown of the power consumption under various operating ...
Hello everyone, I'm currently attempting to connect the STM32F769I-DISCO to a WiFi network using an ESP8266-01 module. I've enabled UART5 and assigned it to the ESP's RX and TX pins, as specified in the STM32F7 datasheet, and I've supplied power to t...
Greetings, I am trying to re- initialize the UART port which i have already initalized with different settings. I Have used HAL_UART_DeInit() before initializing. The problem i face is after the function is run i see the same configuration which i r...
I have been unsuccessful in using TIM1 in Output Compare mode. I was trying to use the code that works for the general purpose timers but I cannot get it to work with the advanced timer TIM1. I read online that it is because it was an advanced timer ...
Hi, the charging logic is implemented based on ADC values and I've designed the logic to capture the peak value from the PWM waveform using an oscilloscope. The main logic works fine during the first charging cycle, but when I try to charge for the s...
Hi there,can i render google maps on B-LCD40-DSI1 Daughter Board, 4" WVGA TFT LCD, board ?
