Ask questions, find answers, and share insights on STM32 products and their technical features.
Posted on October 27, 2016 at 15:02Folks, Has anyone seen this bizarre behaviour where if you write to a timer's CR1 register it also writes to the DMAR register? I have this utterly bizarre thing going on where my timer interrupt was going off at ...
Posted on October 27, 2016 at 09:45Hi, I've read a ton of forum posts here regarding hard fault error encountered when jumping from custom BL to App. But, in my case, it's working fine the first time I did the jump to App. But, when I jump back to B...
Posted on October 27, 2016 at 06:28HelloI am using stm32f373 chip to implement SDADC, USART, Timer, etc, and now I have a problem with interrupt.I tested USART1 interrupt code as below. If I send any character to STM, then it would receive it and se...
Posted on October 27, 2016 at 13:34Hello, I'm using a stm32f030x6. During normal operation i need my swclk-pin (PA14 in my package) to be configured as a UART. However for debugging, i'd like to reconfigure it back and use it as a swclk to use it wi...
Posted on October 27, 2016 at 09:10 Hello, I ported the microchip MiWi stack to STM32(NucleoL152RE) initaly using the mbed hardware librarys. I do not use the mbed compiler, but rather imported it into EmBitz and use the arm-none-eabi...
Posted on October 27, 2016 at 08:22 Helllo, Create a SW4STM32 project using Cubemx. Project in UART, freertos and lwip. I use the task with hal_uart_transmit_it not work.The give a framing error. Added ioc file void StartDef...
Posted on October 26, 2016 at 16:53Hi all. I'm using functions from STVP programming toolkit to implement STM32F051C8 programming in my C# application. I need a command for microcontroller reset after programming. Before I used command EVerifyAll f...
Posted on October 26, 2016 at 21:07Hello everyone. I am having problem with SPI inerface and stm32f4 development board. I am sending 16 bits of information. While the bis are sending the CS must be low and when they are sent must be high. Then goes ...
Posted on October 24, 2016 at 15:36 Hi, We are using a STM32F030C8T6 and are storing configuration data at the end of flash memory. We carved off 4K of the 64K of flash(via the .ld linker file) for the storage area so our config storage ...
Posted on October 26, 2016 at 00:52 Hi all, i use stm32f3 discovery and i develop a project with IAR but i have faced a problem in fixing my loop periode to be more clear : i use the accelerometer and the gyroscope of th stm32f3 discovery , ...
