Ask questions, find answers, and share insights on STM32 products and their technical features.
HiI am using STM32F103C8T6 Microcontroller and tring to configure ADC injected channel with Timer 2 PWM in Register level. but i don't know how to enable the ADC injected channel. help meThanks in advance!
Hello Community,I am making a new project based on an ultra-low power application with a STM32L4A6VGT6. But the problem I am facing is with its inventory.Can anyone tell what is the lead time for this Part Number?Thanks in Advance.
I am using STM32F031 family microcontroller and want to configure the ADC.My application requires current sensing and voltage sensing. For critical measurement like current during PWM ON time, I am using the ADC in external trigger mode, triggered by...
Hello, where can I find the MTBF values?
Hello,Currently I am working on a 16-bit parallel interface where I need to write to and read from the same port. For that I am using GPIO_Init LL library every time I do so. Is this the right method? Will the port data also get reset while doing so....
Hi people!I am currently using a Nucleo-L476RG connected to an analog sensor. On the datasheet of the mcu, in the ADC section, I can read "One external reference pin is available on some package, allowing the input voltage range to be independent fro...
In any mode of FDCAN, receiver doesnot seem to be working. My project is attached..
I'm using an STM32G031F8 for a job right now. I'm coding in GCC assembly, no OS. This thing doesn't even have a hardware divide (much less FPU). I pulled out some old routines from NXP ARM7 chips for doing unsigned div 32 bit by 32 bit and 32 bit ...
Anyone seen this? The politically-correctness crap gets to EE...https://www.oshwa.org/a-resolution-to-redefine-spi-signal-names/
