Resolved! NUCLEO-C5A3ZG STM32C5 QSPI Display Bring up Project
This project tests the STM32C5's XSPI capability to drive QSPI display using the NUCLEO-C5A3ZG M.2/SerialMem connector. GitHub - stm32-hotspot/STM32C5-M2-Serial-Mem-QSPI-Display · GitHub
STM32 MCUs Boards and hardware tools
Ask questions and find answers on STM32 hardware set-ups, including schematic-related challenges, debugging probes, power configurations, and more.
Forum Posts
Problem flashing the code onto STM32F4 DISCO board
Hello!I have installed Keil uVision and STM32 Cube on Ubuntu 18 LTE and when I try to flash the code onto my DISCO board it says that there is no board detected. I have a feel like if ST-Link2 isn't properly installed or maybe there are additional dr...
How to use ST-Link_CLI from network drive?
Attempting to use the otherwise great ST-Link_CLI.exe on a network drive, the tool fails with the error The elf loader file is not accessible.STM32 ST-LINK Utility.exe at the same location doesn't suffer from this issue.Using procmon, I see the corre...
Resolved! How to resolve a problem with ST-Link/2 not connecting to target
I have been working with the trial version of the IAR IDE and with the STM32 processor family.I have been using the ST-Link/2 device to connect to my target for debugging with no problems.I began having a problem when starting debug, I am getting a m...
ST-Link V1 support
Is it in plan to make a support of st-link v1 in future?Thanks!
What exactly does STLink/v2 do on connection to an MCU?
I am currently porting klipper (https://github.com/KevinOConnor/klipper) to stm32f070. It's not a terribly heavy lift considering stm32f042 is currently supported. It currently works great, but only with the stlink connected. If I unplug the STLin...
Resolved! ST Link V2 CLI not working for my STM32F413
Hey guys,i'm currently struggeling with the STM32 CLI to programm my MCU.For my (old) STM32F103 i did setup a script wich worked nicely. Going through the documentation a came uo withST-LINK_CLI.exe -c SN=xxxxxx SWD UR -TVolt -ME -P ../my_firmware.he...
KiCAD library for STM32F769I Discovery boards needed
KiCAD library for STM32F769I Discovery boards needed. I need a KiCAD library to use with the STM32F769I discovery boards so the discovery board can essentially be a component in my project. The plan is to have a daughter board exactly the same size a...
Why does an STM32 ARM Microcontroller have 2 resonators?
Hi guys, I want to build my own Microcontroller development board from scratch, as I was checking the data sheet for the STM32F103C8T6 and STM32405RGT6 processors, there were 2 crystals specified on the data sheet. But when I look at tutorials online...
Resolved! MCU keep heating and I couldn't connect with ST Link
I have a PCB design for STM32F446RE, but after I soldered all the decouple capacitors, the BOOT0 pull down and the MCU, I tried to power it and connect with ST-LINK v2. But the MCU keeps heating and I can't connect. I've searched many times for short...
what is LDO U1 on Stlink-V3set?
My stlink-v3set stop give voltage 3.3v from adapter board MB1440B. Found out that LDO regulator U1 is broken. What a chip installed there?
