Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
The example from STM8L15x-16x-05x-AL31-L_StdPeriph_Lib doesn't explain the way a regular buffer (i.e. 20 - 30 bytes of data) exchange between two MCUs in master and slave mode. Can anyone explain the steps of configuration on both sides?Now I have ST...
Using STM8L051 ADC PD0, 3.7V~4.2V Li-Po battery, 1M+1M resistor to divde the battery voltage, 100nF capacitor to GND.If set PD0 floating input and halt, total current 40uA, if set PD0 push-pull output LOW, 10uA. But the drawback of output LOW is that...
I am working on a project with the STM8S003F3. I need to configure the TIM1 to generate the following digital output signal on PC3:1. Turn PC3 output to High state immediately (<1us) when signal on PC4 input goes Low.2. After PC4 input signal goes Hi...
Hi, I'm trying to reverse engineering a STM8 firmware. till now I can disassemble the binary firmware to get the assembler code using naken_asm : https://github.com/mikeakohn/naken_asmIs it possible to decompile it ? can anyone point me to some tools...
Hi =) I am designing a custom board with an STM8. I have a couple of STM32 Nucleo and eval board but looking at the schematics the ST-link only seem to have the SWD interface, not the SWIM.I do not have any STM8 board from ST have but I have another ...
I got a Motorolla Charger (PSM4604A):This is the circuit:This adapter gives 4.2 V but i need a 5.2 V to charge my smartphone, so i have to rise this constant voltage. But here is a problem. On cold part of circuit there are 3 IC that doing something ...
It shows following error message when I program the board. Please find attached image for this. I am using IAR embedded workbench IDE for my development. Please help me with this as I am facing this issue since two days and not able to crack it.Thank...
