Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Dear STM32 Community, We believe that the example projects provided for the STM32Cube embedded software are a valuable resource when developing projects. We would like to better understand how developers use these examples in their workflow and e...
Hello everyone, I'm developing a kart using an STM32F401 and would appreciate some guidance. Current project status: - STM32F401 - Arduino IDE - Differential drive with two DC motors - BTS7960 motor drivers - Steering logic already working - Se...
Hello,I am working on an STM32N6570-DK project using NetX Duo generated through STM32CubeMX.CubeMX provides PHY options such as RTL8211 and LAN8742. However, my hardware uses an MXL86110I-AQB-R Ethernet PHY connected through the RGMII interface.I wou...
Based on discussion here, conclusion is, that given in 'L45x/'L46x there's no DAC1_CH2, and in 'L41x/'L42x no DAC at all, these are unavailable for inputs selectable for COMP for these sub-families of the low-end 'L4xx family group handled collective...
Hello,I am working with this guide:How to integrate TouchGFX and camera middleware on an STM32N6570-DK And was wondering if there was an easy way to capture snapshots instead of running the camera continuously. I tried setting the mode to CMW_MODE_S...
Hello,I am using STM32CubeIDE/CubeMX with Azure RTOS NetX Duo on a custom board and need to integrate a custom Ethernet PHY that is not one of the PHYs natively supported by CubeMX. I need to add MXL86110I-AQB-R eth phy.I would like to understand the...
Hy,I am trying to implement a code where i am using the I2C3 both in normal mode through the GPDMA and in LPDMA through the linked list.Switching from the normal mode through the LPBAM linkest list works correctly but then moving back always makes th...
I have a custom board with STM32H723VGT6 and external ethernet PHY LAN8742, I have configured MPU, ETH, lwip using cubeMX, for now i just want to ping my device, i am not using RTOS. In debugging, I can see that i am getting ARP requests in network a...
Hello everyone, I am testing a basic dual-core project on the STM32H755ZI-Q Nucleo board. Environment: Board: NUCLEO-H755ZI-QMCU: STM32H755ZITSTM32CubeIDE: latest versionSTM32CubeMX: latest versionST-LINK firmware updatedReference used:Official ST ...
Hello,is there an application example how to configure TIM1 in DMA burst mode and circular transfer? I need asymmetric PWM for 3 phases with dead time insertion... Best regards,
Hi, I am using the STM32H745I-DISCO board and trying to boot an application from the external QSPI flash (MT25QL512ABB). For this purpose, I created two separate projects: Bootloader Project Initializes the QSPI flash. Configures the QSPI in Memor...
