Resolved! NUCLEO-C5A3ZG STM32C5 QSPI Display Bring up Project
This project tests the STM32C5's XSPI capability to drive QSPI display using the NUCLEO-C5A3ZG M.2/SerialMem connector. GitHub - stm32-hotspot/STM32C5-M2-Serial-Mem-QSPI-Display · GitHub
STM32 MCUs Boards and hardware tools
Ask questions and find answers on STM32 hardware set-ups, including schematic-related challenges, debugging probes, power configurations, and more.
Forum Posts
high power consumption of mcu rather than mentioned values in datasheet
hi,I am using Nucleog474ret6 board , and I am measuring current across JP6(header) which is vdd section of MCU.And measuring current using digital multi meter. As measured current value is around 1.98mA(milli Amps) while reset the MCU.But the curr...
Microcontroller dead
Morning everybody The microcontroller on my nucleo board NUCLEO-H755ZI-Q is dead after i have used 5V external power to supply it. I don't understand why
STM32F072 USB Connection
Hello everyone!I have a problem regarding my STM32F072 MCU board that I designed: I cannot connect the board with a terminal properly. Let me explain:1. I've managed the program the board using ST-LINK V2 (Chinese version) and SWD pins.2. When I conn...
ILI9488 TFT EXAMPLE CODE in STM32H563ZIT6
HI, I have a 3.5" ILI9488 TFT LCD Without touch. I want to interface it using microcontroller with SPI Interface.,Can anyone please share ILI9488 SPI tft display 320X480 resolution interfacing with stm32 sample code.
Resolved! Spi communication with MAX22192 SPI IO expander and STM32 ncleoG474RE
HI community,I got my hands on a MAX22192 evaluation kit (SPI GPIO expander) , currently attempting to communicate with it. While I can receive the input status from the IC, it doesn't respond to the commands I'm sending to it through NUCLEO G474RE.T...
provide example code for multiple interrupt
Dear Team,' please provide example code for multiple peripheral interrupts(ADC,timer)in a same example code with mxcube configuration.board: stm32c031c6 Best Regards,Deepa P@nevase123
STEVAL-STWINBX1 datalogger board - Python GUI not working
I am using the STEVAL-STWINBX1 development board and have downloadedthe FP-SNS-DATALOG2 software to the board.I compiled and flashed the FP-SNS-DATALOG2 software to the board using the ST Cube IDE and a Segger J-Link.I am trying to use the Python GUI...
Resolved! Nucleo-144 (F756ZG) stopped working after cut-off ST-Link
Hello, I recently bought Nucleo-144 board (variant F756ZG) to one of my project. I used DFU to upload firmware and external power supply using VIN pin (7.5 VDC). It works perfect until I decided to remove ST-Link part to reduce board size. After that...
Resolved! Regarding development boards
We are using STM32H743BIT6 microcontroller in our project. Which is the development board that we need to buy and use for this microcontroller for prototyping and development purpose? Can we use STM32H753I-EVAL2?
Resolved! Implementing SWD programming protocol for flashing STM32 chips
Hello.I am developing a development board (to sell to customers eventually), for which I want to have my own flashing dongle. Now, I have posted in another thread asking about the software that is in the ST-Link devices, and the response I got is tha...
