Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Posted on October 13, 2015 at 16:41When I go to compile the sample code from ST's site, I get the error ''Can't Access File: .Idea_Temp\IDEABLD.BAT in Project directory. Check access rights .....'' I tried searching for IDEABLD.BAT, and I can't find...
Posted on September 06, 2012 at 09:37Hi, I am debugging software for an STM8S105x6, using the programmer from the STM8S-Discovery board and STVD software. All went fine, until suddenly an error popped up while entering debug mode: '** Connection err...
Posted on November 10, 2015 at 14:56 Hi All, I am during writing bootloader for STLUX processor (base on STM8). Both, bootloader and main program uses own interrupt vector table. The STM8 processor has fixed interrupt vector table at 0x8000 ...
Posted on November 03, 2015 at 03:05Dear All,When STM8 power on or after reset, how about value of RAM (0x00 or 0xff or another value).I try to search on the internet about RAM structure of STM8 but don't have any documentThanks.
Posted on October 29, 2015 at 10:00 I am new to STM I have written following code in iar but couldn't able to receive from uart. // // This program shows how you can output a message on the UART on // the STM8S microcontroller. // // T...
Posted on November 01, 2015 at 16:00Hello everyone, I am using STM8S105 and STM8S003. Can we create delay 1 microsecond with TIMER4? I can create delay 1ms, 100us, 10us but can not for delay 1us. Can we? Thank you!
Posted on October 29, 2015 at 10:08I am working on STM8S3F3P , when i tried to standard peripheral for this microcontroller i keep getting error that select predetermined chip from STM/A.Is there any tutorial to learn this..
Posted on October 26, 2015 at 07:18I am currently using STM32 to communicate with RTC chip M41T00SMF6, does anyone has a reference schematics for M41T00S ? Thanks.
Posted on October 15, 2015 at 15:12Hello All, Is there any way to run STM8L101 at a frequency about 200 kHz to save some microAmps?BR, Dmitry #frequency #stm8l101
Posted on October 19, 2015 at 21:45Hello, We are planning to start to use STM8 automotive microcontroller in one of our product. To start with we downloaded STVD development suite (C:\Program Files (x86)\STMicroelectronics\st_toolset) and Cosmic (C:...
