Ask questions and find answers on connectivity ICs, focusing on protocols and I2C challenges on STM32 Nucleo boards and BlueNRG products.
I am currently evaluating a power line carrier (PLC) communication solution and plan to use the ST8500. The client’s equipment is quite densely packed, with several hundred units, and requires auxiliary communication via the power line to promptly ...
We have followed single conversion mode as outlined in: L9966 lambda sensor interface – rev. 1.0.0 1 L9966 lambda sensor interface Application Note. But the result register is all zeros.Is there anything missing?The register nameing is not consistant...
Hello everyone, I find your new product, the ST87M01-1301, an interesting alternative to Nordic or Simcom. However, I haven't found any hardware design guides for the module yet. Could you please provide some? A schematic would be really helpful, sho...
I have eval kit EVALSTPM33 from Digikey. When I plug it into my PC USB port, I see a red LED near the USB port, and in the Windows device manager it shows up as com port #6. If I connect to that com port and try to read a register in software from ht...
I use DTM project,download to my board,but it is not running.I use my project it can running normal.How to solve it ,thanks
hiii,Do you plan to support BLE TMAP on this module?
Hi Does ST have any WIFI chip with FTM? Thanks
Im trying to get the reading from distance sensor SICK DT35 through STEVAL-IOM001V1 which uses the L6360 IC via STSW-IOLINKGUI to get the proper reading we need to upload the IODD file of the sensor which I'm not be able to do with the GUI. There's n...
Hello,we have developed our own RF modules based on the S2-LP transceiver and we are currently characterizing their maximum usable sensitivity.Measurement setupTX and RX are connected through a calibrated variable attenuator.The transmitter sends 500...
Hi,I can´t find the QConn_flash tool for the ST67W61....Best regards,Achim
