Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
I tried out the STBB1 with the evalboard to drive a load of 500mA.My trials were successfull. I did them by switching on my power supply with 5V and afterwards I was switching the 500mA Load on and off at the output. -> everything cool.Now I have my ...
I have a fixed voltage version of the ST1S06xx, but I am struggling to make it work as there is essentially no information on what the Vo pin does, apart from "output voltage in fixed voltage version". That is the only mention of the existence of the...
Hi,is it possible to use the STPMIC1 on an I2C Bus where another slave does clock stretching? In the datasheet it says that the STPMIC uses the SCL to shift data. For my understanding the clock strechting of the other slave shouldn't bother the STPMI...
Hi, We are using the STPM34 in one of our products.We are facing a problem with phase calibration. Every time we try to execute the calibration process we get an error bigger than (+1) or smaller than (-3). According to the datasheet, the formula of ...
For the devices mentioned above, i couldn't find related software drivers to be used in the host MCU, only datasheets available.for L9788 , even the datasheet doesn't have any information regarding control and configuration of the IC.I am planning to...
Hi, I am interested in prototyping with the L9788 multi functional IC. However I am unable to find any documents which has detailed information about the IC, apart from the basic datasheet. It is possible for me to get the necessary documents for thi...
Hi, I want to ask a question. I have STM32 power monitor shield and is it possible to measure current without powering the device by the shield? I want to use battery to power the device and measure the current drown from battery.
the schematic for STPM33 is atttached.
We’re moving the ST Community to a new platform to give you a better and more reliable community experience.
