Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
I am using powerSTEP01 to drive a stepper motor with the specs as follows:The motor stalls at 1190 step/s due to resonance as suggested in application note:https://www.st.com/resource/en/application_note/dm00061093-voltage-mode-control-operation-and-...
My objective is to develop a sensored BLDC control.Right now I am collecting information and I find myself in the following situation.The motor has the following characteristics: V = 48 / 52VDC i I = 15 / 20A.I have seen the following STDRIVE101i eva...
How to know what curve do I need? In what cases do I need temperature compensation? Datasheet says "Reference voltage generators with programmable independent temperature compensation". What does word "independent" mean? Datasheet says only that:
I am testing a L7815CV to charge a 12V Battery (I will use this in a solar system with a 20W solar panel where the input voltage might range from 0-22V and Imax=1.3A)When supplying an input voltage of 21V to the L7815CV, the L7815CV won't let any cur...
Hello,I am using an L6472 stepper motor controller.I have an EVAL6472H board coupled over SPI to a nucleo L4R5Zi board on SPI.I am running the motor controller on Step Clock mode. I am setting the hold current to 200mA. When the motor runs, I am upda...
I wanna to implement USBPD with stusb1602 and stm32f103.have 3 USBPD Port and implement control and operation with stm32f103.but i could not find any related information. According to document, that need to use stm32f072 to implement USBPD. ans so is...
I thought it was because of the capacitive load (25uF), so I tried to reduced it to 15uF, but haven't gotten any changes. I tried also to reduce the slew-rate on Vin, still no significant difference. Is this because of the soft-start?.
