Others: hardware and software

Hi, I have started working on STM8L Dev board. I want to integrate HAL driver. Can anyone tell where I can find this?

hi. I'm using stm8001j3 but I have problem with timer 2 and 4 .I have enabled clock for this timers and do all setting but it doesn't work it seems that clock is disconnected .can anyone help ?

 Timer 1 work's well without any problem.the code works properly with stm8s105k4 without any problem.

Can one generate an interrupt from Port C pin 0 or pin 1 on the STM8L051F3?

There do not seem to be definitions for Port C to be used as such.  //EXTI_SelectPort(EXTI_Port_C);  //EXTI_SetHalfPortSelection(EXTI_HalfPort_C_LSB, ENABLE);  //EXTI_SetPortSensitivity(EXTI_Port_C, EXTI_Trigger_Falling);Is there any way to trigger a...

Why the cosmic compiler produce this error

Posted on July 28, 2009 at 06:35Why the cosmic compiler produce this error

STM8S UART2 Std_Periph Continuous Rx Data Reception

I have implemented the same methodology as explained in the below post:http://embedded-lab.com/blog/continuing-stm8-microcontroller-expedition/12/I am trying to receive data that is 6 bytes long on the Rx pin using interrupts. When calling ReceiveDat...

In the design, I am using STM8AF6286 controller and want to connect 2 slaves over 1 SPI but with 2 separate chip selects. But STM8AF6286 having single chip select pin. what should I do? is there any other controller in 32 pin, QFN package available?

SWIM ICP programming on STM8L050j3

Hello,I'm trying to program and STM8L050J3 from another MCU through ICP programming on the SWIM interface. Section 5.6.1 of PM0051 presents a sequence where it is required to apply a reset and release it after the SWIM_CSR register hase been configur...