Ask questions and find answers on connectivity ICs, focusing on protocols and I2C challenges on STM32 Nucleo boards and BlueNRG products.
Posted on December 05, 2016 at 21:32Hello folks,while experimenting with an idw01m1 module, I am experiencing deauthentication with the message:WIND:40:WiFi Deauthentication 3With the '2015' firmware, the module was unable to reconnect until WiFi wa...
Posted on December 09, 2016 at 16:49Hi there! I am using M95512-A125 serial EEPROM in my automotive project. My question is, when i'm going to do some operation on the EEPROM, how do I know if it is completely IDLE? I know that bit WIP in the status...
Posted on December 07, 2016 at 00:39Hi,Referring to this question: https://community.st.com/0D50X00009Xke8kSAB Dear customer,I'll try to give a feedback to you:•Can scripts be run in a normal Python debug environment rather than using BlueNRG_Scri...
Posted on December 09, 2016 at 08:48Hi, I want to read some Wmbus frames using SPIRIT1. Do anyone happen to know where i can find those libs: wmbus_appli.c, wmbus_link.c, wmbus_phy.c. They were mentioned in one of ST pdf about Wmbus protocol: /exter...
Posted on December 05, 2016 at 20:57the main issue is that the pins doesn't correspond and it requires to unsolder the resistance R10,R12,R15 and solder in R11,R13,R16my idea was just curv or cut the pins and create a loopback between the other pins...
Posted on December 08, 2016 at 14:47hi, please help me a wiring schematic of IC ATIC39-B4 A2C08350, thanks and good luck to you
Posted on December 05, 2016 at 21:13shield of stm32f746g discoveryshield of the idb04a1is there a solution (difficult to unsolder the resistance: can we curve or cut the pin and stripe irq csn and clk ?)Br,Christophe#bluenrg #stm32f746g-disco
Posted on December 06, 2016 at 15:28Hi,I'm using the Bluenrg-ms chipset with firmware version 7.1.e (0x715). Everything works fine, except from the authorization settings. Each device can connect to the BLE without any request for permissions (PIN)....
Posted on May 30, 2016 at 07:10I have our BlueNRG device set up to use a fixed pin for pairing. I am able to successfully pair with Apple iOS decvices and windows phone when I enter the correct PIN when prompted by the device. However when connectin...
Posted on November 24, 2016 at 11:26Hello, I am using SPWF01.11 FW3.5 as webserver as described in a previous post. This webserver is made of 1 HTML Frameset (main.html) + 3 HTML frames (m.html / sm.html / data.html) to override the 4ko limitation. ...
