Imaging (sensors)

VL53L0X Restore Factory Default Calibration

Hello, is there a way (after applying a calibration such as offset calibration or crosstalk calibration) to return the sensor back to the default calibration that was performed at ST? If so, which I2C commands would perform this job?

I wish to use the VL6180 within a pressurised chamber. What pressure can the package withstand? Max pressure would be ~15bar.

We have recently developed a Hardware board having STM32L4KB and VL53L1X , we connected VL53L1X I2C3 port. we are running the STM32 VL53L1X API we get the I2C data as 255, -1. Request you please suggest a solution for the same

We checked the status of each step and the status for VL53L1_WaitDeviceBooted = -13

LV53L3CX and similar sensors low level software programiing data

Hello all.I'm looking for any serious software documentation for LV5x sensors and... I cant't find any?!?For serious software documentation I understand precision description of all registers and macro procedures i.e. calibration, data collection etc...

Interrupt reset on e.g VL6180X

I want to use the TOF unit to detect when a physical object is passing. The Threshold detection shall rise an interrupt signal which I use to initiate a function. As I understand the mentioned VL6180X, the interrupt must be cleared each time via a...

To know exactly what the value returned by the VL53L0X sensor means.

Hello, I'm Jee Kyungsub, a student studying at RISE Lab at Sungkyunkwan University.​We are conducting study on mapping using VL53L0X proximity sensor to your company. But we met some problems while we were researching.​To proceed with the mapping, we...

VL53L1 Nucleo Pack: Can one change the ROI in the GUI without resetting all the calibration values?

I am using the VL53L1 Nucleo Pac with the Flight Sense GUI supplied by ST. I am trying to evaluate different ROI settings but everytime I change the ROI, all the calibration settings seem to be cleared. Can one change the ROI in the GUI without reset...

Minimum consumption Vl53L3x

Hi, I plan to use the VL53L3:The goal is to power it with 1300mah battery, 200ms measurement refresh rate, 2 years life expectancy. The product could reach <100µA in this conditions ?Thanks