Discuss power management solutions. Ask questions and find answers on voltage configurations, short circuit protection, and programming.
Posted on June 01, 2018 at 13:13STM32 Motor Control webinar - June 4th, 15:00-16:00!Sign up here: http://www.st.com/content/st_com/en/about/events/events.html/stm32-motor-control-webinar-emea.html Join ST for a 1-hour webinar to explore the new STM3...
Posted on May 28, 2018 at 16:37Goodmorning,i'm using the steval 3d printer board as prototype for my project, i need to use NEMA 23 motors and hold in torque for some time (even hours).after 1 or 2 minutes the l6474 return overtemperature error, and...
Posted on June 01, 2018 at 11:40Hi,I am using the battery monitor - stc3117. The application uses the default OCV table. When the battery monitor is initializated, vbat is set to 3V (on the battery simulator), but Ocv register is 3.3V. It is the...
Posted on May 30, 2018 at 15:10i need HIgh side switch for 5 V to 50V-60V application, Load will be inductive load.Need feature of inverse current protection for inductive load.Thanks in advance...
Posted on May 30, 2018 at 15:05for high side switch IPS160H, what value of inductive load it can support ? (without the diagnotic signal falult condition)
Posted on October 26, 2017 at 17:26Hello! I am using l6470 on X-Nucleo IHM02A1 with the STM32F4 discovery board with the SPI interface (daisy chaining). I am working on the precision of an autonomous robot with the four mecanum wheels of 10 cm. I am...
Posted on July 09, 2013 at 00:07I've gotten past all of my comms issues and seem to be able to talk to the L6470 reliably now. However, I'm having trouble actually getting it to move. I keep getting OCD events even when commanding moves at low acc...
Posted on May 24, 2018 at 15:02Can you share with us time response and turn off time of the STEF01 electronic fuse against high surge currents in detail? Do you provide any application note for this device againts lightning induced transients, inrus...
Posted on May 24, 2018 at 09:31Dear All,I have been working on a project where I need to Switch on Two devices using Two BTA06 controlled by Digitally Opto-Triac. Line and Neutral are same for both.Attached is the schematic.I have issue that when I ...
Posted on May 23, 2018 at 19:49I am using an IHM02A1 board with a Nucleo F401RE. I have ported the drivers into a new CubeMX project and I can run the example program. The example program's stepper parameters (in parameters.c) seem to be working but...
We’re moving the ST Community to a new platform to give you a better and more reliable community experience.
