Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
I wish to use STVD to set up a new workspace on a mapped common drive but it whereas I can see and go to a mapped drive with the Atmel IDE etc the STVD IDE doesnt appear to recognise it. Is this a known limitation or something I am doing wrong?
Hello everyone.I'm fresher,I start learning ARM recently,I need connection two STM8L152C6 discovery with I2C protocol.I try hard but I'm fail.I hope someone can help I do it.Thank you so much.
I set up a project that generates the makefiles for the STM8 target. It almost works, just the interrupt vector table is not updated with the definitions in the code.The interrupts are set up and work. I can see that from the button press on the disc...
For the mass production i am want gang programmer or I need to program through UART without any bootl-oader firmware.
I work on a project inside eclipse IAR EW plugin. Now I would like to debug from there, too. Just like for STM32. Is that possible? If so, how?Thanks
here is the code https://gist.github.com/goog/222020c4d46e751f591559f3f3ff06e0BUT the PD0 does not output clockI'm new to stm8 and reference STM8S_StdPeriph_Lib example
I have a big problem when using USART on STM8L-DISCOVERY. I studied the reference manual but it didn’t help me. I use library SPI. Could you send me a project working with usart on STM8L-DISCOVERY please!!!! NOTE: This question and answer originated ...
Hi there,I want to expand array size until 3000. (i.e. arr[3000]). I have 4KB RAM.currently I can get value till arr[1500].I tried different options to expand size but no success. Please see below image.How to expand array size? Thanks ,Gopal
I used to choose a 10K resistor.But something seems to been wrong. Can anybody help with this? please!
I am currently using STM8S003 and use to option byteDuring normal use, sometimes the program suddenly disappears.Then when re-burn, it will fail and the following message will show:Errors while setting configuration with MCU name STM8S103F3P: gdi-err...
